Xerox 604P18057 manual Using Stored Programming

7 Stored Programming

This chapter describes how to use the Stored Programming feature to simplify multiple operations into a simple procedure. First, you register a series of operations in a job number. Later, you can select the job number to execute the stored operations when required. You can store operations (both on the touch screen and the control panel) up to immediately before pressing the <Start> button on the control panel.

NOTE: You cannot store operations performed on the [Setup Menu] screen.

Using Stored Programming

Follow the steps below to select and execute a job number.

1.Press the <All Services> button on the control panel.

2.Select [Stored Programming] on the touch screen.

3.Select a job number to be executed.

4.Change the settings as necessary.

5.Press the <Start> button on the control panel.

NOTE: On the [Stored Programming] screen, only job numbers that have been programmed are active and selectable.

Stored Programming

You can store up to 58 consecutive operations in each job number, up to the total of 40 job numbers. To register the required operations in a job number, follow the steps below.

NOTE: A job number remembers not only operations performed on the touch screen but also the buttons pressed on the control panel.

NOTE: If, after a job has been stored in Stored Programming, you then change the default settings in System Settings, or make changes to Job Flow Sheet, Job Template, Address Book, Comment, etc., the operation registered for each job will also change.

Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User Guide 139