Xerox 604P18057 Receiving Buffer - Port9100, Print Area, Substitute Tray, Paper Type Mismatch

Print Mode Settings

Receiving Buffer - Port9100

Allows you to change the input buffer memory capacity for Port9100 interface within the range of 64–1,024 KB in 32 KB increments using the scroll buttons or the numeric keypad. The currently available memory will be displayed at the top of the screen with the following message: “Memory Available: XXX MB.”

Other Settings

Use this feature to specify a printable area and replacement method when paper runs short.

1.Select [Other Settings] on the [Print Mode Settings] screen.

2.Use the scroll buttons to switch between screens.

3.Perform the necessary operations.

4.Select [Close].

Print Area

Sets the printable area to [Normal] or [Extended]. If you select [Normal], the printable area excludes a margin 4.1 mm (0.16 inches) wide along all four edges of the paper. If you select [Extended], the printable area is extended to leave about 2 mm (0.08 inches) of margin along the edges.

Substitute Tray

Sets the substitute tray when the machine cannot detect the paper tray corresponding to the document size with the auto paper selection.

Display Message

A message requesting paper supply is displayed without switching paper trays.

Use Larger Size

Switches to the tray loaded with the next larger size of paper and prints the document in its original size.

Use Nearest Size

Switches to the tray loaded with the paper in the size closest to the selected paper. Image size may be automatically reduced as required.

NOTE: The job sent from the PC takes priority over the job set on the machine.

Paper Type Mismatch

Sets whether to display or hide the confirmation screen when a paper type mismatch occurs.

Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User Guide 223