Aastra Telecom Pro 160 manual Support English Support French Support Spanish

		Configuring AastraLink Pro 160 System and Network Parameters
		Configuring System Settings
	AastraLink Web UI
Step	Action
7	To support additional languages for the auto-attendant announcement, click on any of the following
	parameters. Only the system language set by the administrator during initial greenfield configuration
	is enabled by default.
	•	Support English
	•	Support French
	•	Support Spanish
	Note: Adding additional languages may require the IP phones to reboot, in order to download the
	new language pack.
8	To specify settings for the Line Type, Line Range/Boost, and Line Profile, you must use the
	AastraLink Tuning Wizard. For instructions, see “Using the AastraLink Audio Tuning Wizard” on
	page 4-85.
9	In the “Echo Cancel” field, echo cancellation is enabled by default. This parameter enables echo
	cancellation for the FXO lines. Disable this parameter by unchecking the box.
	Note: Aastra recommends echo cancellation should always be enabled in normal use; re-enable it
	after running the tuning wizard if required.
10	Specify the decibels to use for power when Real Time Transport Protocol (RTP) is sent TO the line, in
	the “RTP to Line Power (dB)” field.Valid range is +6 dB to –14 dB. Default is -3.
	Note: Aastra recommends you DO NOT change the default setting for this parameter because of
	FCC regulatory compliances.
11	Specify the decibels to use for power when Real Time Transport Protocol (RTP) is sent FROM the
	line, in the “Line to RTP Power (dB)” field. Valid range is +6 dB to –14 dB. Default is 0.
	Note: Aastra recommends you DO NOT change the default setting for this parameter because of
	FCC regulatory compliances.
12	Click <Save> to save your changes.

41-001190-01 Rel. 1.1, Rev. 00 4-7