Chapter 6

X330WAN CLI Commands

This chapter provides a complete list of all X330WAN module-related CLI commands. Each command that appears on the list is accompanied by a detailed description, including the proper syntax. The list is presented in alphabetical order to help you locate commands easily.

Introduction: About the CLI

The CLI is command-line driven and does not have any menus. To activate a configuration option, type the desired command at the prompt and press Enter.

To configure the X330WAN, you must either be in supervisor mode, or enter the configure context. Generic commands are performed from the configure context.

If you are in supervisor mode or have entered the configure context, you can enter any of the following contexts:

Controller (X330W-2DS1 only)

Interface Console

Interface Fast Ethernet

Interface FabricFastEthernet

Interface Serial

Interface Loopback

Other contexts

Layer 1 (E1/T1) commands are performed from the controller context, and Layer 2/Layer 3 (Fabric, PPP, Frame Relay, Fast Ethernet, IP) commands are performed from the various Interface contexts.

To exit a context, type exit.

You can use all show commands in user mode.

For a list of all Controller commands, see "Controller CLI Commands (X330WAN- 2DS1 Only)" on page 115.

For a list of all Interface Fast Ethernet commands, see "Fast Ethernet Interface CLI Commands" on page 112.

For a list of all Interface FabricFastEthernet commands, see "FabricFast Ethernet Interface CLI Commands" on page 114.

For a list of all Interface Loopback commands, see "Loopback CLI Commands" on page 153.

Avaya X330WAN User’s Guide

87

Page 109
Image 109
Avaya manual X330WAN CLI Commands, Introduction About the CLI