General: Device Commands

Note: If N/A is displayed for the EW_Archive file, the Device Manager software is not loaded correctly. Download the Device Manager software again.

ds-mode

Use the ds-modecommand to set the controller’s mode.

Note: After setting the controller’s mode, this command:

1.Erases startup-config.

2.Resets the device.

Syntax

ds-mode [e1t1]

Parameters

e1 Sets the device to E1 mode. All controllers are set to operate as E1.

t1 Sets the device to T1 mode. All controllers are set to operate as T1. This is the default.

Example

X330WAN-2DS1-1(configure)# ds-mode e1

Your startup-config file will be erased!

Your telnet session will be disconnected.

This operation may take a few minutes

The WAN module will reset, in order to make the required change. Do you want to continue (Y/N)?

Note: If this command is entered when the correct mode is selected (for example, entering ds1-mode e1 when the device is already in E1 mode), no errors are generated.

Caution: This action takes approximately 20 seconds. Do not enter any commands after confirming restart until after the restart process is complete.

Avaya X330WAN User’s Guide

95

Page 117
Image 117
Avaya X330WAN manual Ds-mode e1t1