Chapter 6 X330WAN CLI Commands

loopback remote (Controller context)

Use the loopback remote command to ask the device on the far end to put itself into loopback mode.

Note:

1.This command can only be performed if the controller is set to T1.

2.Use this command during line setup and maintenance.

Syntax

loopback remote {linepayload}

Parameters

line

The controller loops the external line signal back towards the

 

network without reframing the DS1 signal.

payload

The controller loops the external line signal back towards the

 

network and reframes the DS1 signal. (This option is available in the

 

ESF framing mode and only when FDL is defined.)

Example

X330WAN-2DS1-1(config-controller:1)# loopback remote line

no channel group (Controller context)

Use the no channel group command to delete a channel group.

Syntax

no channel-group <channel-num>

Parameters

channel-numID number to identify the channel group. The valid range is from 0 to 23 for T1 lines, and from 0 to 30 for E1 lines.

Example

X330WAN-2DS1-1(config-controller:1)# no channel-group 2

no loopback (Controller context)

Use the no loopback command to disable the loopback mode.

Syntax

no loopback

124

Avaya X330WAN User’s Guide

Page 146
Image 146
Avaya X330WAN Loopback remote Controller context, No channel group Controller context, No loopback Controller context