General Layer 2 Interface CLI Commands

 

 

Parameters

 

type

The type of this interface. Select one of the following:

 

FastEthernet, Serial, FabricFastEthernet, Loopback, or

 

Console.

identifier • For a FastEthernet interface — An integer (1).

For a Serial interface — <port>:<channel-group>(for PPP) or <port> (for Frame Relay).

<port> — Either 1 or 2.

<channel-group>— For E1, an integer, 0-30.

For T1, an integer, 0-23.

• For a FabricFastEthernet interface — 1[:<vlan>]

<vlan> - An integer, 1-3071.

• For a Loopback interface — An integer, 1-99.

Note: This command has different outputs for PPP and Frame Relay, and for X330W-2DS1 and X330W-2USP. Two output examples are provided.

Output Example for X330W-2DS1 with PPP on both controllers:

X330WAN-2DS1-1(super)# show interfaces

FabricFastEthernet 1 is up, line protocol is up

MTU 1500 bytes, Bandwidth 100000 Kbit

Reliability 255/255 txLoad 1/255 rxLoad 1/255

Encapsulation ARPA

Link status trap disabled

Full-duplex, 100Mb/s

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, Last output 00:00:08

Last clearing of 'show interface' counters 00:06:24 5 minute input rate 81966 bits/sec, 155 packets/sec 5 minute output rate 8 bits/sec, 0 packets/sec

0 input drops, 0 output drops, 0 unknown protocols

115 packets input, 7360 bytes

115 broadcasts received, 0 giants

0 input errors, 0 CRC

4 packets output, 256 bytes

0 output errors, 0 collisions

FabricFastEthernet 1:1 is up, line protocol is up

Physical address is 00.40.0d.bf.20.01,

Internet address is 4.0.0.1, mask is 255.0.0.0

Avaya X330WAN User’s Guide

155

Page 177
Image 177
Avaya X330WAN manual Output Example for X330W-2DS1 with PPP on both controllers