Policy CLI Commands

ip simulate (Interface context)

Use the ip simulate command to check the Policy for a simulated packet. The command contains the addressed list number and the packet parameters.

Note: This command is executed from the Serial, Loopback, Fast Ethernet, and FabricFastEthernet interfaces.

Syntax

ip simulate <policy-list-number> <direction> [<priority>] [<dscp-value>]<source> <destination> [<protocol> [<source port> <destination port> [<established>]]]

Parameters

 

policy-list-number

An integer from 100 to 149, where 0 is the default list.

direction

inout

priority

fwd0fwd1..fwd7

dspc value

dscp0dscp1..dscp63

source

Source IP address.

destination

Destination IP address.

protocol

iptcpudpinteger from 1 to 255.

source port

An integer from 1 to 65535.

destination port

An integer from 1 to 65535.

established

Value of TCP established bit.

Example

X330WAN-2DS1-1(config-if:FastEthernet1)# ip simulate 100 in

192.67.85.12 193.76.54.25

Avaya X330WAN User’s Guide

217

Page 239
Image 239
Avaya X330WAN manual Ip simulate Interface context, 192.67.85.12