Controller CLI Commands (X330WAN-2DS1 Only)

loopback diag (Controller context)

Use the loopback diag command to put the T1 or E1 line into loopback mode.

Note: Use this command during line setup and maintenance.

Note: Only one type of loopback can be defined at any given time.

Syntax

loopback diag

loopback local (Controller context)

Use the loopback local command to put the T1 or E1 line into loopback mode.

Note: Use this command during line setup and maintenance.

Note: Only one type of loopback can be defined at any given time.

Syntax

loopback local {linepayload}

Parameters

line

The controller loops the external line signal back towards the

 

network without reframing the DS1 signal.

payload

The controller loops the external line signal back towards the

 

network and reframes the DS1 signal.

Example

X330WAN-2DS1-1(config-controller:1)# loopback local line

Avaya X330WAN User’s Guide

123

Page 145
Image 145
Avaya X330WAN manual Loopback diag Controller context, Loopback local Controller context, Loopback local linepayload