Avaya X330WAN De pre-mark Map-class context, Encapsulation frame-relay Serial interface context

Chapter 6 X330WAN CLI Commands

de pre-mark (Map-class context)

Use the de pre-markcommand to set the threshold, in percent of CIR, for pre-marking of non-high priority traffic. The no form of this command restores the default value.

Note: This command is relevant when voice and data traffic share a single Virtual Circuit. A higher threshold value provides more bandwidth for data traffic, potentially reducing voice quality. Too low a value might provide more bandwidth to voice traffic than is needed, and the data traffic is discarded. You obtain the exact threshold value for your uses via trial and error.

Syntax

[no] de pre-mark<threshold-percent>

Parameters

threshold-percentThe threshold, in percent of CIR. The default is 100%.

Example

X330WAN-2USP-1(super-map-class)# de pre-mark 35

encapsulation frame-relay (Serial interface context)

Use the encapsulation frame-relaycommand to set the encapsulation of the Serial interface to a Frame-Relay interface. The no form of this command reverts the encapsulation of the Serial interface to PPP.

Note: PPP is the default encapsulation.

Syntax

[no] encapsulation frame-relay [<type>]

Parameters

type The type of encapsulation: ietf.

Example

X330W-2USP-1(super-if:Serial2)# encapsulation frame-relay ietf

142 Avaya X330WAN User’s Guide