Avaya X330WAN manual Interface Console, Ppp authentication Console interface context

Console (RS232) Interface CLI Commands

interface Console

Use the interface Console command to enter the Console interface (interface console context) to PPP configure mode. For LAN interfaces, use this command to create the interface. The no form of this command sets the default Console parameters.

Syntax

[no] interface Console

Example

X330WAN-2DS1-1(configure)# interface Console

ppp authentication (Console interface context)

Use the ppp authentication command to set the type of password that should be sent for authentication, if necessary.

Syntax

pppauthentication {papchapnone}

Parameters

pap Password Authentic Protocol. Unencrypted password sent for authentication.

chap Challenge Handshake Authentication Protocol. Encrypted password sent for authentication.

none No password sent.

Example

To select the CHAP authentication protocol:

X330WAN-2DS1-1(config-if:CON)# ppp authentication chap

speed (Console context)

Use the speed command to set the PPP baud rate to be used by asynchronous PPP ports.

Note:

1.This command is executed from the Console interface.

2.The peer baud-rate must be set to the same value.

Syntax

speed {96001920038400}

Avaya X330WAN User’s Guide 111