Avaya X330WAN manual Cablelength short Controller context

Chapter 6 X330WAN CLI Commands

-7.5db	Sets the transmit attenuation to 7.5 dB.
0db	Sets the transmit attenuation to 0 dB. This is the default value.

Note: If you can not configure the hardware’s receive sensitivity, the receive sensitivity is fixed at 36 dB and is unaffected if you enter gain26 or gain36.

Example

X330WAN-2DS1-1(config-controller:1)# no cablelength

The following example changes the CLI receive sensitivity to match the actual receive sensitivity of the hardware and adds 15 dB of attenuation to the transmit signal:

X330WAN-2DS1-1(config-controller:1)# cablelength long gain36 -15db

cablelength short (Controller context)

Use the cablelength short command to configure transmit attenuation for a cable length (line build-out) of 655 feet or shorter for a T1 trunk with a DSX-1 interface. This command configures the attenuation using the loop length. The no form of this command restores the default value.

Note: This command can only be performed if the controller is set to T1.

Syntax

cablelength short {133ft266ft399ft533ft655ft}

Parameters

133Cable length of 0 to 133 feet. This is the default value.

266Cable length of 134 to 266 feet.

399Cable length of 267 to 399 feet.

533Cable length of 400 to 533 feet.

655Cable length of 534 to 655 feet.

116 Avaya X330WAN User’s Guide