Chapter 6 X330WAN CLI Commands

description (Controller context)

Use the description command to set the description of the E1/T1 interface. This description appears both in the ifAlias and the circuitIdentifier MIB values for that interface. The no form of this command removes the controller’s description.

Note: This command can also be executed from the Serial, Loopback, Fast Ethernet, and FabricFastEthernet interfaces.

Syntax

[no] description <desc>

Parameters

desc A string describing the E1/T1 interface. The string may contain blanks and can be up to 255 characters long.

Example

X330WAN-2DS1-1(config-controller:1)# description "E1 controller"

X330WAN-2DS1-1(config-controller:1)# no description

fdl

Use the fdl command to define an FDL type. FDL is used to define a remote loopback for the module or to receive the far-end counters.

The no form of this command disables the FDL.

Note:

1.This command can only be performed if the controller is set to T1.

2.Use this command only when ESF framing is defined.

Syntax

[no] fdl <fdl-mode>

Parameters

fdl-mode

ansi att both

Example

X330WAN-2DS1-1(configure)# fdl ansi

120

Avaya X330WAN User’s Guide

Page 142
Image 142
Avaya X330WAN manual Description Controller context, Fdl, No description desc