Avaya manual Controller CLI Commands X330WAN-2DS1 Only, Cablelength long Controller context

Controller CLI Commands (X330WAN-2DS1 Only)

ip-interfaceThe IP interface number within this interface (as a number of IP interfaces might be bound to an Layer 3 interface). An integer from 0 to 1024.

Example

X330WAN-2DS1-1(configure)#interface FabricFastEthernet 1

X330WAN-2DS1-1(configure)#interface FabricFastEthernet 1:1

X330WAN-2DS1-1(configure)#no interface FabricFastEthernet 1.1

To enter interface FabricFastEthernet context for port 1, vlan 1, with an IP-interface of 1:

X330WAN-2DS1-1(configure)#interface FabricFastEthernet 1:1.1

Controller CLI Commands (X330WAN-2DS1 Only)

This section contains a list of all Controller related CLI commands.

cablelength long (Controller context)

Use the cablelength long command to configure transmit and receive levels for a cable length (line build-out) longer than 655 feet for a T1 trunk with a CSU interface. This command configures the levels using gain/attenuation. The no form of this command restores the cablelength long parameters to their default values (Tx=0db level, Rx=gain26).

Note: This command can only be performed if the controller is set to T1.

Syntax

[no] cablelength long {gain26gain36} {-15db-22.5db-7.5db 0db}

Parameters

gain26 Sets the receive sensitivity to 26 dB if you can configure the hardware’s receive sensitivity. This is the default value. However, it is recommended to enter gain26 so that the CLI entry matches the actual value.

gain36 Sets the receive sensitivity to 36 dB if you can configure the hardware’s receive sensitivity.

-15dbSets the transmit attenuation to 15 dB.

-22.5dbSets the transmit attenuation to 22.5 dB.

Avaya X330WAN User’s Guide 115