Avaya Framing X330WAN-2DS1 Controller context, Idle-character X330WAN-2DS1 Controller context

Controller CLI Commands (X330WAN-2DS1 Only)

framing (X330WAN-2DS1 Controller context)

Use the framing command to select the frame type for the E1 or T1 data line. The no form of this command sets the controller’s framing type to the default value.

Syntax

[no] framing <frame-type>

Parameters

frame-type		The framing method to use:
•	sf	Selects super frame framing (dsx1D4). This is the default value
		for T1 lines.
•	esf	Selects extended super frame framing (dsx1ESF).
•	crc4	Selects CRC4 framing (dsx1E1-CRC-MF). This is the default value
		for E1 lines.

•no-crc4Selects no-CRC4 framing (dsx1E1-MF).

•unframed The line is not framed.

Note: Use this command in configurations where the router or access server is intended to communicate with an E1 or T1 fractional data line. The service provider determines which framing type (sf, esf, or crc4) is required for your E1/T1 circuit.

Example

X330WAN-2DS1-1(config-controller:1)# no framing

The following example selects extended super frame as the T1 frame type:

X330WAN-2DS1-1(config-controller:1)# framing esf

idle-character (X330WAN-2DS1 Controller context)

Use the idle-charactercommand to set the bit pattern used to indicate an idle line. The no form of this command restores marks as the idle line indicator (default).

Syntax

[no] idle-character {flagsmarks}

Avaya X330WAN User’s Guide 121