Chapter 6 X330WAN CLI Commands

Parameters

flags Flags are transmitted to indicate an idle line.

marks Marks (all ones) are transmitted to indicate an idle line. This is the default.

Example

X330W-2DS1-1(super-if:Serial2)# idle-character marks

linecode (Controller context)

Use the linecode command to select the line-code type for an E1 or T1 line. The no form of the command restores the default line-code type of transmission.

Syntax

For T1 lines:

linecode {amib8zs}

For E1 lines:

linecode {amihdb3}

Parameters

ami Alternate Mark Inversion line-code type. Valid for both T1 and E1 controllers.

b8zs B8ZS line-code type. Valid only for a T1 controller. This is the default value for T1 lines.

hdb3 High-Density Bipolar 3 line-code type. Valid only for a E1 controller. This is the default value for E1 lines.

Note: Use this command in configurations where the router or access server must communicate with E1 or T1 fractional data lines. The T1 service provider determines which line-code type, ami or b8zs, is required for your T1 circuit. The E1 service provider determines which line-code type, ami or hdb3, is required for your E1 circuit.

Example

X330WAN-2DS1-1(config-controller:1)# no linecode

The following example specifies B8ZS as the line-code type for a T1 line:

X330WAN-2DS1-1(config-controller:1)# linecode b8zs

122

Avaya X330WAN User’s Guide

Page 144
Image 144
Avaya X330WAN manual Linecode Controller context