Layer 3 CLI Commands

Parameters

value The space available for the IP address table. When you decrease the number of entries, it may cause the table to be relearned more frequently. If you do not enter a value, then the current ARP Cache size is shown. The range of accepted values is 128 to 16384.

Example

To set the maximum number of ARP cache entries to 8000:

X330WAN-2DS1-1(configure)# ip max-arp-entries 8000

To restore the maximum number of ARP cache entries to its default:

X330WAN-2DS1-1(configure)# no ip max-arp-entries

ip max-route-entries

The ip max-route-entriescommand exists for compatibility with P550. There is no limitation on the size of the routing table, except for the amount of available memory. The no form of this command sets the maximum number of route entries in the routing table to its default value.

Syntax

[no] ip max-route-entries <value>

Parameters

value The number of entries. The range of accepted values is 100 to 20000.

ip netbios-rebroadcast (Interface context)

Use the ip netbios-rebroadcastcommand to set the NETBIOS rebroadcasts mode on an interface. The no form of this command disables NETBIOS rebroadcasts on an interface.

Note: This command is executed from the Serial, Fast Ethernet, and

FabricFastEthernet interfaces.

Syntax

[no] ip netbios-rebroadcast [<direction>]

Avaya X330WAN User’s Guide

177

Page 199
Image 199
Avaya X330WAN manual Ip max-route-entries, Ip netbios-rebroadcast Interface context, No ip max-route-entries value