Avaya manual Ignore-dcd X330WAN-2USP Serial interface context, Interface Serial X330WAN-2DS1

Chapter 6 X330WAN CLI Commands

Parameters
flags	Flags are transmitted to indicate an idle line. This is the default.
marks	Marks (all ones) are transmitted to indicate an idle line.

Example

X330W-2USP-1(super-if:Serial2)# idle-character marks

ignore-dcd (X330WAN-2USP Serial interface context)

Use the ignore-dcdcommand to configure the serial interface to monitor the DSR/CTS signals instead of the DCD signal as the line up/down indicator. The no form of this command restores DCD monitoring as the line status indicator (default).

Syntax

[no] ignore-dcd

Example

X330W-2USP-1(super-if:Serial2)# ignore-dcd

interface Serial (X330WAN-2DS1)

Use the interface Serial command to create and/or enter interface Serial context. For LAN interfaces, use this command to create the interface. The no form of this command deletes an IP interface.

Syntax

[no] interface Serial <if-number>[<if-link-type>]

Parameters

if-number	Comprised of: port:channel-group[.ip-interfacesub-
	interface[.ip-interface]].
• port	The controller number (port number) for this serial port. For
	the X330W-2DS1, this value is either 1 or 2.

•channel-groupAn integer. For E1, between 0 and 30; for T1, between 0 and 23.

•ip-interfaceThe IP interface number within this interface (as a number of IP interfaces might be bound to a Layer 3 interface). An integer from 0 to 1024.

if-link-typePoint-to-point.

132 Avaya X330WAN User’s Guide