Avaya X330WAN manual Timers basic Router-RIP context, Timers spf Router-OSPF context

Chapter 6 X330WAN CLI Commands

192.168.66.24
Primary IP	Address:	192.168.66.23
Primary IP	Address was chosen by default
Preemption	Mode:	enabled
# of times	Master:		1
# of received Advertisements:			0
# of transmitted Advertisements:			13

# of received Advertisements with Security Violations: 0

timers basic (Router-RIP context)

Use the timers basic command to set RIP timers. The no form of this command sets the RIP timers to their default values.

Syntax

[no] timers basic <update> <invalid>

Parameters

update RIP update timer, in seconds (minimum 30).

invalid RIP invalid route timer, in seconds (minimum 30).

Example

X330WAN-2DS1-1(configure router:rip)# timers basic 30 180

timers spf (Router-OSPF context)

Use the timers spf command to configure the delay between runs of OSPF’s SPF calculation. The no form of this command restores the default value, 3 seconds.

Syntax

[no] timers spf <spf-holdtime>

Parameters

spf-holdtimeThe time in seconds of the delay between runs of OSPF’s SPF calculation. The range of acceptable values is 1 to 3600.

Example

X330WAN-2DS1-1(super)# timers spf 5

208 Avaya X330WAN User’s Guide