Avaya X330WAN manual Crc

Chapter 6 X330WAN CLI Commands

Field	Description
Received	The amount of broadcasts received. This value advances only
broadcasts	for Ethernet interfaces.
Received giants	Displays the number of packets discarded due to them
	exceeding the maximum packets size.
Received	Displays the number of packets received on the interface that
unknown	were discarded due to them using an unknown or unsupported
protocols	protocol.
Input errors	The total number of errors for packets received. Includes a sum
	of the following errors.
CRC	The Cyclic Redundancy Checksum. This usually indicates
	transmission problems on the data link.
Abort	An illegal sequence of 1 bit was detected on a Serial interface.
	This usually indicates a clocking problem.
Packets output	The total number of messages transmitted.
Bytes output	The total number of bytes transmitted, including data and MAC
	encapsulation packets.
Output errors	The total number of errors that prevented packets from being
	transmitted.
Collisions	Displays the number of retransmitted messages due to an
	Ethernet collision (non-Ethernet ports=0).
Interface resets	The number of DTR and RTS resets (down-up fluctuation) due
	to an inoperable Serial line, or when the USP interface is
	administratively brought up again (USP interfaces only).
Carrier transitions	The number of times the carrier detect signal state changes on a
	Serial interface.
Signal status	DCD, DSR, DTR, RTS, and CTS signal status (X330W-2USP
	only).
ARP type	The Address Resolution Protocol type used.
ARP timeout	The Address Resolution Protocol timeout value.
Full/Half duplex	The duplex state of the interface (for Fabric and Fast Ethernet
	interfaces only).

162 Avaya X330WAN User’s Guide