
Configuring the X330WAN
6Connect the Console port to the modem’s
7Dial into the module from a remote station, and open a Telnet session to the PPP interface IP address configured in step 3.
Checking the Modem Configuration
After establishing a modem connection, use the show interface console command to display information regarding your modem interface. Verify that the output information is correct.
Establishing a Telnet Connection
Perform the following steps to establish a Telnet connection to the X330WAN for configuration of WAN parameters. Telnet directly to one of the IP interfaces of the X330WAN:
1Connect your station to the network.
2Verify that you can communicate with the X330WAN using the
ping <host> [<interval> [<size>]] command to the IP of the X330WAN. If there is no response, check the IP address and default gateway of both the X330WAN and the station using the show ip route command.
3From the Microsoft Windows taskbar of your PC, click Start and then Run (or from the DOS prompt of your PC), then start the Telnet session by typing: telnet <IP address of X330WAN>
For example: telnet 149.49.32.134
Note: You can also Telnet the IP address of the P330 stack. If you Telnet the IP address of the stack, a connection is established with the Switch CLI entity of the Master module of the stack.
If you want to connect to the X330WAN CLI entity, use the session wan <module number in stack> command.
4When prompted for a Login Name, enter the default name root.
5When prompted for a password, enter root. You can now configure the X330WAN.
Avaya X330WAN User’s Guide | 19 |