Avaya manual Avaya X330WAN User’s Guide 127

	Controller CLI Commands (X330WAN-2DS1 Only)
Remote alarm	Any alarms detected by the controller are displayed. The possible
	alarms are:
	• Transmitter is sending remote alarm.
	• Transmitter is sending alarm indication signal (AIS).
	• Receiver has loss of signal.
	• Receiver is receiving AIS.
	• Receiver has loss of frame.
	• Receiver has remote alarm.
	• Receiver has no alarms.
	• Receiver has a major alarm.
Framing	Shows the current framing type. The default framing type for E1
	is CRC4. The default framing type for T1 is SF.
Line Code	Displays the current line code. The default line code for E1 is
	HDB3. The default line code for T1 is AMI.
Clock Source	Displays the current clock source. The possible clock sources are
	either Line or Internal.
Channel Group	Displays the channel group number and timeslots.
Data in current	Displays the current accumulation period (from 1-900 seconds),
interval	which rolls into a 24 hour accumulation every 15 minutes. The
(347 seconds	oldest 15 minute period falls off the back of the 24 hour
elapsed)	accumulation buffer.
Line Code	Displays either no line code violations, the occurrence of a
Violations	Bipolar Violation, or the occurrence of an Excessive Zeros error
	event.
Path Code	Displays one of the following:
Violations	• No path code violations.
	• A frame synchronization bit error in the SF (for T1) and
	no- CRC4 (for E1) frame types.
	• A CRC4 error in the ESF (for T1) and CRC4 (for E1) frame
	types.
Slip Secs	Displays if there is a replication or deletion of the payload bits of
	a domestic trunk interface (DS1) frame. A slip might happen
	when there is a difference between the timing of a synchronous
	receiving terminal and the received signal.
Fr Loss Secs	Displays the number of seconds an Out of Frame (OOF) error is
	detected.

Avaya X330WAN User’s Guide 127