Avaya X330WAN manual Configuring E1/T1 Interfaces

Chapter 3 Initial Configuration

The primary management interface has changed.

For this change to take effect, you need to copy running-config startup-config and then reset the device.

Enter the copy running-configstartup-configand reset commands at this stage.

Configuring E1/T1 Interfaces

All CLI commands mentioned in this section are described in Chapter 6: X330WAN CLI Commands.

For a list of X330WAN default settings, see "X330WAN Default Settings" on page 28, or use the show controllers <port number> command to display all of the current settings.

To configure E1 or T1 interfaces:

1Use the show controllers <port number> command to check if your controller’s mode is configured as E1 or T1.

Use the ds-mode[e1t1] command to set the controller’s mode to E1 or T1. Changing the line type requires resetting the module.

2Use the controller [e1t1] <port number> command to enter the context of the port to be configured.

The prompt changes to X330WAN-2DS1-N(super-controller:n)# where N is the switch number and n is the port number.

3Use the following commands if you want to change the clock source, frame type and linecode parameters from their default settings:

clock source [lineinternal]

framing [sfesf] for T1 lines or framing [crc4no-crc4unframed] for E1 lines.

linecode [amib8zs] for T1 lines or linecode [amihdb3] for E1 lines. cablelength [longshort] for T1 lines.

For T1 mode proceed to step 5.

4Use the channel-group<channel-number> timeslots <timeslot-list> command to specify the channel group and time slots to be mapped. For example, typing

channel group 1 timeslots 1,3-5,7configures time slots numbered 1, 3-5 and 7 to be mapped in channel-group number 1.

Proceed to step 6.

5Use the channel-group<channel number> timeslots <timeslot list> speed [5664] command to specify the channel group, time slots to be mapped and DS0 speed in kbps. For example, typing

channel group 1 timeslots 1,3-5,7 speed 64 configures time slots numbered 1, 3-5, and 7 to be mapped in channel-group number 1 and the DS0 speed to 64 kbps.

22 Avaya X330WAN User’s Guide