Configuring the X330WAN

PMI is configured, the following message appears:

The primary management interface has changed.

For this change to take effect, you need to copy running-config startup-config and then reset the device.

Enter the copy running-configstartup-configand reset commands at this stage.

Configuring the FabricFast Ethernet Interface

All CLI commands mentioned in this section are described in Chapter 6: X330WAN CLI Commands.

To configure a FabricFast Ethernet interface:

1Use the interface FabricFastEthernet <if-number>command to enter the FabricFast Ethernet interface context, where the if-number format is port[:vlan[.ip-interface index]].

Note: You do not need to include the ip-interface index if you configure only one IP interface.

2 Use the ip address command to assign an IP address to the interface.

For example: To configure the IP addresses 10.10.10.1 on VLAN 2 and 20.20.20.1 and 30.30.30.1 on VLAN 3 perform the following:

X330WAN-2USP-1(super)#interface FabricFastEthernet 1:2

X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# ip address

10.10.10.1 24

X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# exit X330WAN-2USP-1(super)# interface FabricFastEthernet 1:3.1 X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.1)# ip address

20.20.20.1 24

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.1)# exit X330WAN-2USP-1(super)# interface FabricFastEthernet 1:3.2 X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.2)# ip address

30.30.30.1 24

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.2)# exit

Note: The first IP interface created in the X330WAN automatically becomes the PMI, described in detail on page 34. It is recommended to configure the Loopback interface as the first Layer 2 interface and to configure an IP interface on it. After the PMI is configured, the following message appears:

Avaya X330WAN User’s Guide

21

Page 43
Image 43
Avaya manual Configuring the FabricFast Ethernet Interface, X330WAN-2USP-1super#interface FabricFastEthernet, 10.10.10.1