Avaya X330WAN manual Configuration Example 1 for Site a Single VC Between Sites

Chapter 4 Operational Concepts and Configuration Examples

•The IP phones are configured with the following DSCP tagging:

—Voice = DSCP 46

—Voice control = DSCP 34

•Network IPs (all 24 mask):

—IP phones - 1.1.1.0 (VLAN 1)

—Data - 11.11.11.0 (VLAN 2)

—Serial - 2.2.2.1

—Gatekeeper - 149.49.54.81

—MGP - 149.49.54.82

—VoIP (MGP) - 149.49.54.83

Site B contains four IP phones and a data LAN connected to a P333T-PWR switch in a stack with a G700 Media Gateway. The G700 Media Gateway houses an X330W-2USP expansion module that is connected to a Frame Relay network via a 192Kbps Frame Relay encapsulated V.35 interface.

Following are the connection details for Site B:

•A single VC with:

—CIR = 128Kbps

—DLCI = 16

•The IP phones are configured with DSCP tagging:

—Voice = DSCP 46

—Voice control = DSCP 34

•Network IPs (all 24 mask):

—IP phones - 3.3.3.0 (VLAN 1)

—Data - 33.33.33.0 (VLAN 2)

—Serial - 2.2.2.2

—MGP - 4.4.4.10

—VoIP (MGP) - 4.4.4.11

Configuration Example 1 for Site A - Single VC Between Sites

Following is the configuration procedure for the X330WAN-2USP, as shown in Figure 4.11. Commands with footnotes are described at the end of the configuration procedure.

•Loopback and PMI interfaces configuration:

X330WAN-2USP-1(super)# interface Loopback 1 X330WAN-2USP-1(super-if:Loopback1)# ip address 10.10.10.10 24

The Primary management interface has changed. Please copy the running configuration to the start-up configuration file, and reset the device.

X330WAN-2USP-1(super-if:Loopback1)# exit X330WAN-2USP-1(super)# copy running-configstartup-configX330WAN-2USP-1(super)# reset

64 Avaya X330WAN User’s Guide