Chapter 2

Installation

 

 

X330W-2DS1 Front Panel and LEDs

The front panel of the X330W-2DS1 has two columns of four LEDs each, one for each Serial (WAN) port in the access router module. There is also a Fast Ethernet port, and a Console port for directly connecting a terminal. Between the LEDs and the Console port there is a RST/FIV button for manually resetting the module.

Figure 2.1 X330W-2DS1 Front Panel

Table 2.1 describes the LEDs on the front panel of the X330W-2DS1.

Table 2.1 X330W-2DS1 LED Descriptions

LED Name

Color

Description

LED Status

 

 

 

 

 

 

 

 

 

 

 

ON - Module is initializing, or

 

 

 

when an alarm state exists on an

 

 

 

interface.

ALM

Red

Alarm

 

OFF - Initialization successful,

 

 

 

module software functioning

 

 

 

properly, no alarm conditions on

 

 

 

an interface.

 

 

 

 

 

 

 

ON - Port is being initialized or

TST

Green

Test

loopback is active.

 

OFF - Port initialization completed

 

 

 

 

 

 

and loopback is not active.

 

 

 

 

 

 

 

ON - At least one PPP/Frame

ACT

Yellow

Active

Relay session is active.

 

OFF - No active PPP/Frame Relay

 

 

 

 

 

 

session.

 

 

 

 

 

 

 

ON - A signal is detected on the

SIG

Green

Signal

port.

 

OFF - No signal is detected on the

 

 

 

 

 

 

port.

 

 

 

 

12

Avaya X330WAN User’s Guide

Page 34
Image 34
Avaya X330WAN manual X330W-2DS1 Front Panel and LEDs, LED Name Color Description LED Status