Configuring the X330WAN

The default DS0 speed is 56 kbps

6Type exit to return to Supervisor mode.

The prompt returns to X330WAN-2DS1-N(super)#

7Use the interface Serial <port:channel-group<.ip-interface>> command to configure each channel group as a virtual Serial interface. Specify the port number and channel group number to modify.

For example: typing interface Serial 1:1 configures a Serial interface on port number 1 with a channel group number 1.

8Change the encapsulation to Frame Relay if required, using the encapsulation frame-relaycommand.

If Frame Relay encapsulation was selected, continue with step 13.

Note: After the Serial interface is created, its default encapsulation is PPP.

9Use the ip address <ip address> <mask> command to assign an IP address and subnet mask to the interface.

10Type exit to return to Supervisor mode.

The prompt returns to X330WAN-2DS1-N(super)#

This completes the procedure for PPP encapsulation.

11Repeat step 4 through step 10 if you want to configure another serial interface on the same E1/T1 port.

12Repeat step 2 through step 10 if you want to configure another E1 or T1 interface.

13Use the frame-relay lmi commands to change the Local Management Interface (LMI) parameters from their default values if required, or use the frame-relaytraffic-shapingcommand to activate Traffic Shaping on the Frame Relay interface. For more information on Traffic Shaping, refer to "Traffic Shaping and Marking" on page 47.

14Type exit to return to Supervisor mode.

15Use the interface serial <if-number>[<if-link-type>] command to enter the Frame Relay Sub-interface context. (For example, typing interface serial 2:3.1 point-to-pointcreates a Point-to-Point type Sub-interface 1 on port 2, channel-group 3.)

Note: Currently only Point-to-Point Sub-interface types are supported.

16Configure a Data Link Connection Identifier (DCLI) for the Sub-interface using the frame-relayinterface-dlci<DLCI number> command.

17If required, configure a Priority DLCI Group using the frame-relaypriority-dlci-group<DLCI1>[<DLCI2>[<DLCI3>[<DLCI4>]]] command.

Avaya X330WAN User’s Guide

23

Page 45
Image 45
Avaya manual Configuring the X330WAN