Avaya X330WAN manual Ip rip send-receive Interface context, Ip rip split-horizon Interface context

Layer 3 CLI Commands

ip rip send-receive (Interface context)

Use the ip rip send-receivecommand to set the RIP send and receive modes on an interface. The default state is talk-listen. The no form of this command sets the RIP to talk (i.e., send report).

Syntax

[no] ip rip send-receive-mode <mode>[<default route metric>]

Parameters
mode	talk-listen- Sets RIP to receive and transmit updates on the
	interface.
	talkdefault-listen- Sets RIP to receive updates on the
	interface and send only a default route.
	listen-only- Sets RIP to receive updates on the interface and
	not transmit them.

default route Integer value.

metric

Example

X330WAN-2DS1-1(super-if:Serial:1:1)# ip rip send-receivetalk-listen

ip rip split-horizon (Interface context)

Use the ip rip split-horizoncommand to enable the split-horizon mechanism. The no form of this command disables the split-horizon mechanism. By default split-horizon is enabled.

The split-horizon mechanism prevents information about routes from exiting the router interface through which the information was received. This prevents routing loops.

Note: This command is executed from the Serial, Loopback, Fast Ethernet, and FabricFastEthernet interfaces.

Syntax

[no] ip rip split-horizon

Example

X330WAN-2DS1-1(super-if:Serial:1:1)# no ip rip split-horizon

Avaya X330WAN User’s Guide 185