Minolta 330 5.8 - Spot Deletions, continued

magicolor 330 - Base Engine Service Manual 5-19

Primary Fault Isolation Procedures

5.8 - Spot Deletions, continued

Step Actions and Questions Yes No

FUSER INSPECTION

1. Generate a test print and slide the Fuser Assembly out of the

printer just as the sheet of paper exits the Fuser.

2. Inspect the image on the sheet of paper just after the paper exits

the Fuser.

Is there a normal test print image on the sheet of paper befor

entering the Fuser but the image has visible spot deletions after it

exits the Fuser?

Go to step 6

1. Replace the Oil Roll Assembly (RRP 9.82).

2. Generate a test print.

3. Inspect the image on the sheet.

Is the image now normal, without spot deletions as it exits the

Fuser?

Problem

Solved Replace the

Pressure Roll

(RRP 9.83) and

the Heat Roll

(RRP 9.84)

71. Replace the Xerographic Cartridg e (RRP 9.48).

2. Generate a test print.

Is the image now normal, without spot deletions?

Problem solved Go to step 8

DEVELOPER ASSEMBLY INSPECTION

1. Remove the Top Cover (RRP 9.3).

2. Turn the Rotary Frame and inspect the Magnet Roll of each of

the four Developer Assemblies.

Do the Magnet Rolls of each Developer Assembl y appear smooth,

evenly formed, without any low spots, and without obvious con-

tamination?

Go to Suspect

Components Replace the

faulty Devel-

oper Assembly