magicolor 330 - Base Engine Service Manual 9-139
Removal and Replacement Procedures
RRP 9.67 Rotary Frame Assembly (PL7.2.2)
Removal
1. Remove the Yellow Developer Assembly (RRP 9.59).
2. Remove the Magenta Developer Ass embly (RRP 9.61).
3. Remove the Cyan Developer Ass embly (RRP 9.63).
4. Remove the Black Developer Assembly (RRP 9.65).
5. If present, remove the screw securing the Rotary Knob the Rotary Shaft.
6. Release the Knob latch by inserting a sc rewdriver blade through the slot in the front of the Knob and
pull the off of the Shaft (Figure 1).
7. Remove the Rotary Motor Assembly (RRP 9.114).
8. Remove the Dispense Motor A ssembly (RRP 9.116).
9. Remove the Developer Clutch Assembly (RRP 9.117).
10. Remove the Developer Tie Plate (RRP 9.118).
11. Remove the Rotary Sensor (RRP 9.68).
12. Remove the large E rin g securing the Rear Rotary Bearing to the rear of the printer frame and slide the
Rear Bearing off of the Rotary Frame shaft (Figure 2).
13. Slide the Front Rotary Bearing o ff of the Rotary Frame shaft.
14. Slide the Rotary Frame Assembly t o the front of the printer frame.
15. Pull the rear of the Rotary Frame Assembly free of the rear frame, swing the rea r of the Assembly out
of the printer and remove the Assembly.
Replacement
1. Insert the Rotary Frame Assembly front sha ft through the cutout in the front of the printer frame.
2. Swing the rear of the Rotary Frame Assembl y into the printer and insert the Assembly rear shaft into
the cutout in the rear of the printer frame.
3. Slide the Front Rotary Bearing, lip of Bear ing facing out, onto the Rotary Frame shaft and into the cut-
out in the front of the printer frame.
4. Slide the Rear Rotary Bearing, lip of Bearing facing out , onto the Rotary Frame shaft and into the cut-
out in the rear of the printer frame.
5. Use a large E ring to secure the Rotary Frame shaft to the Rear Rotary Bearing to the frame.
6. Reinstall the Rotary Senso r (RRP 9.68).
7. Reinstall the Developer Tie Plate (RRP 9.118).
8. Reinstall the Developer Cl utch Assembly (RRP 9.117).
9. Reinstall the Dispense Motor Assembly (RRP 9.116).
10. Reinstall the Rotary Motor Assemb ly (RRP 9.114).
11. Reinstall the Rotary Knob.
12. Reinstall the Black Developer Ass embly (RRP 9.65).
13. Reinstall the Cyan Developer Asse mbly (RRP 9.63).
14. Reinstall the Magenta Developer A ssembly (RRP 9.61).
15. Reinstall the Yellow Developer Assembly (RRP 9.59).