magicolor 330 - Base Engine Service Manual 9-261
Removal and Replacement Procedures
RRP 9.128 Controller Fan (PL14.1.2)
Removal
1. Remove the Right Cover (RRP 9.8).
2. Remove the Top Cover (RRP 9.3).
3. Disconnect the Controller Fan P/J 314 from the Controller PWB.
4. Remove the two screws secur ing the Controller Fan to the printer frame and remove the Fan.
Replacement
1. Position the Controller Fan with the label facing up and the wires close to the grommet hole.
1. Reinstall the Fan onto the pr inter frame.
2. Use two screws to secure the Fan to the prin ter frame.
3. Route the Fan wire through th e grommet hole.
4. Reconnect the Controller F an P/J 314 to the Controller PWB.
5. Reinstall the Top Cover (RRP 9.3).
6. Reinstall the Right Cover (RRP 9.8).