magicolor 330 - Base Engine Service Manual 9-267
Removal and Replacement Procedures
RRP 9.131 Fuser Chute Fan (PL9.4.10)
Removal
1. Remove the Fuser Assembly (RRP 9.80).
2. Remove the two screws securing the Horizontal Chute to the Fuser Tray and remove the Chute (Fig-
ure 1).
3. Remove the four screws securing the Bo ttom Cover to the Fuser Tray and remove the Cover.
4. Remove the Fuser Chute Fan from the Fuser Tray (Figure 2).
5. Disconnect the P/J 80 from the Fan.
Replacement
1. Reinstall the Fuser Chute F an into the slot in the Fuser Tray.
2. Route the Fan wire harness t hrough the slots in the Fuser Tray and out through the hole in the rear of
the Tray.
3. Reconnect P/J 80 to the Fan.
4. Reinstall the Bottom Cover onto the Fuser Tray and use four screws to secure the Cover.
5. Reinstall the Horizontal Chute onto the Fuser Tray and use two screws to secure the Chute.
6. Reinstall the Fuser Assembl y (RRP 9.80).