magicolor 330 - Base Engine Service Manual 9-241
Removal and Replacement Procedures
RRP 9.118 Developer Tie Plate (PL12.1.4)
Removal
1. Remove the Lower Exit Assembly (RRP 9.1 01).
2. Remove the Rear Cover (RRP 9.4).
3. Remove the Inner Cover (RRP 9.2).
4. Remove the wire and Wire Clamp fr om the Developer Tie Plate.
5. Remove the two screws securing the Developer Tie Plate to the rear of the printer frame.
6. Remove the two screws securing the Dev eloper Tie Plate to the front of the printer frame.
7. Slide the Tie Plate up and out of the pr inter frame.
Replacement
1. Position the Develop er Tie Plate as shown.
2. Slide the Tie Plate down into position, behind the P/J connector s that are located on the rear of the
printer frame.
3. Use two screws to secure the Developer Tie Plate to the front of the printer frame.
4. Use two screws to secure the Developer Tie Plate to the rear of the printer frame.
5. Reinstall the Wire Clamp a nd wire onto the Developer Tie Plate.
6. Reinstall the Inner Cover (RRP 9.2).
7. Reinstall the Rear Cover (RRP 9.4).
8. Reinstall the Lower Exit Assem bly (RRP 9.101).