magicolor 330 - Base Engine Service Manual 9-219
Removal and Replacement Procedures
RRP 9.107 Exit Chute Switch (PL10.2.13)
Removal
1. Remove the Lower Exit Assembly (RRP 9.1 01).
2. Squeeze the latches holding th e Exit Chute Switch to the Lower Exit Assembly and remove the Switch.
Replacement
1. Position the Exit Chute Switch against the Lower Exit As sembly.
2. Line up the positioning pin and the two latches o n the Sensor with the three holes in the Lower Exit
Assembly.
3. Press the Sensor again st the Assembly until the latches snap into place.
4. Reinstall the Lower Exit Assem bly (RRP 9.101).