magicolor 330 - Base Engine Service Manual 3-15
Primary FIPS: Error Messages
3.12 - Error Message: Incorrect OPC Drum 2
There is a CRU Memory problem.
Logic control on the MCU PWB detected that the memory initial value of the installed OPC Drum is wrong.
Step Actions and Questions Yes No
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially or
completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the components
1OPC DRUM RESEAT & REINITIALIZE
1. Slide the OPC Drum a few in ches out of the printer.
2. Reinstall and lock the OPC Drum.
3. Switch off the printer.
4. Wait a minute.
5. Switch on the printer.
Does the error message still appear?
Go to step 2 Problem
solved
2Replace the OPC Drum (RRP 9.48)
Does the error message still appear?
Go to step 3 Problem
solved
3MCU PWB INSPECTION
1. Switch off the printer.
2. Follow RRP 9.123 to access the M CU PWB.
3. Disconnect P/J 16 from th e MCU PWB.
4. Reconnect P/J 16 to the MCU P WB.
5. Switch on the printer.
Does the error message still appear?
Go to step 4 Problem
solved
4Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
Go to suspect
components
Problem
Solved