Minolta 330 2

magicolor 330 - Base Engine Service Manual 3-51

Primary FIPS: Error Messages

Image density exceeded design specifications.

Logic control on the MCU PWB detected that the first 70mm of the lead edge of the four color image about to be

printed exceeds the design specification for total image density. The specification is 280% or less image density. For

example, a density setting of 100% for each of the four colors creates a layered four color image with a combined

density of 400%.

Step Actions and Questions Yes No

SUSPECT COMPONENTS

The following components are associated with this specific prob-

lem. One or more of these components may have failed partially

or completely. If you cannot isolate the problem using this FIP,

replace each component listed below, one at a time, until the prob-

lem disappears.

• Wiring and connectors linking the components

1PRINTER RESTART

1. Switch off printer main power.

2. Wait one minute.

3. Switch on printer main power.

4. Send the same print requ est to the printer.

Does the error message still appear?

Go to step 2 Treat as inter-

mittent. If

problem reoc-

curs, resume

troubleshoot-

ing at step 2.

2PRINT REQUEST CANCELLATION

1. Cancel the print request that is causing the error mes-

sage.

2. Print another, much less comp lex, color image.

Does the second image generate the same error message?

Replace the

MCU PWB

(RRP 9.123)

Do not send

overly dense

images to the

printer.