magicolor 330 - Base Engine Service Manual 9-165
Removal and Replacement Procedures
RRP 9.80 Fuser Assembly (PL9.1.1)
Removal
1. Slide Tray 1 a few inches out of the printer so you can access the screw that prevents the Fuser
Assembly from sliding out of the printer.
2. Remove the screw secu ring the Fuser Assembly to the printer frame.
3. Slide the Fuser Assembly a few i nches out of the printer.
4. Lift the end of the Fuser Assembly and pull the Assembly out of the printer.
Replacement
1. Lift the end of the Fuser Assembly as you i nsert the Assembly side rails into the guide wheels inside
the printer.
2. Lower the end of the Fuser Assembly and slide the Assembly into the printer.
3. Slide Tray 1 a few inches out of the printer.
4. Reinstall the screw to secure the Fuse r Assembly to the printer frame.