magicolor 330 - Base Engine Service Manual 9-181
Removal and Replacement Procedures
RRP 9.88 Temperature Sensor Assembly (PL9.2.24)
Removal
1. Remove the Upper Fuser Assembly (RRP 9.87).
2. Remove the screw secu ring the Temperature Sensor to the Upper Fuser Assembly.
3. Disconnect P/J 75 from the Fuser Exit Sensor.
4. Remove the Temperature Sensor and the wire harness from the Upper Fuser Assembly.
Replacement
1. Insert the Temperature Sensor through the opening in the top of the Upper Fuser Assembly.
2. Position the Sensor so th e sensing head faces up.
3. Align the screw hole and position ing tab on the Sensor with the screw hole and positioning hole on the
Upper Fuser Assembly.
4. Use one screw to secure the Temperature Sensor to the Upper Fuser Assembly.
5. Route the wire harness along the top of the Upper Fu ser Assembly, down the side of the Front Fuser
Cover, across the Fuser Bottom Plate, under the Rear Fuser Cover, and out the Rear of the Upper
Fuser Assembly.
6. Reconnect P/J 75 to the Fus er Exit Sensor.
7. Secure the wire har ness under all of the harness clips that are molded into the Upper Fus er Assembly.
8. Reinstall the Upper Fuser Assem bly (RRP 9.87).