magicolor 330 - Base Engine Service Manual 9-257
Removal and Replacement Procedures
RRP 9.126 Environment Sensor (PL13.2.5)
Removal
1. Remove the Xerographic Cartri dge (RRP 9.48).
2. Slide the Main Paper Han dling Assembly out of the printer.
3. Disconnect P/J 105 fro m the Environment Sensor.
4. Remove the screw securing the Ground Wir e and the Environment Sensor to the printer frame, push
the Wire aside and remove the Sensor.
Replacement
1. Reinstall the Environment Se nsor onto the printer frame.
2. Align the Sensor so the positioning h ole and the screw hole in the Sensor line up with the positioning
tab and screw hole in the printer frame.
3. Reinstall the Ground Wir e over the screw hole in the Sensor.
4. Use one screw to secure the S ensor and Ground Wire to the frame.
5. Reconnect P/J 105 to the E nvironment Sensor.
6. Slide the Main Paper Han dling Assembly into the printer.
7. Reinstall the Xerographic C artridge (RRP 9.48).