magicolor 330 - Base Engine Service Manual 9-37
Removal and Replacement Procedures
RRP 9.16 Turn Roll Assembly (PL3.1.11)Removal
1. Remove Tray 1 from the printer.
2. Remove the Main Paper Handling Assembly (RRP 9.36).
3. Remove the two screws securing the Turn Chute to the printer fram e and remove the Turn Chute.
4. Remove the Turn IN Chute (RRP 9.20).
5. Remove the two screws secur ing the Tray Stopper to the printer frame and remove the Stopper.
6. Remove the E ring securing the front of the Turn Roll Shaft to the front bearing.
7. Disconnect the Turn Arm Spring from the printer frame.
8. Remove the E ring securing the roun d cover that is over the Turn Arm Assembly Gear and remove the
cover.
9. Slide the rear of the Turn Roll Shaft out of the Turn Arm Assembly.
10. Slide the front of the Turn Roll Shaft out of the f ront bearing and remove the Turn Roll Assembly.
Replacement
1. Slide the front bearing ov er the front of the Turn Roll Shaft.
2. Slide the front of the Turn Roll Shaft throu gh the cutout in the front of the frame.
3. Push the Shaft far enough through the cutout so you can slide the rear of Shaf t into the Turn Arm
Assembly.
4. Reinstall the round cover ov er the Turn Arm Assembly Gear and use an E ring to secure the cover to
the Gear.
5. Reconnect the Turn Arm Spring to the print er frame.
6. Use an E ring to secure the fron t of the Turn Roll Shaft to the front bearing.
7. Reinstall the Tray Stopper to the prin ter frame and use two screws to secure the Stopper to the frame.
8. Reinstall the Turn IN Chute (RRP 9.20).
9. Push in on the rear arm o f the Turn IN Chute and insert the arm into the hole in the rear of the frame.
10. Reinstall the Turn Chute onto the printer frame, ma king sure you slide the bottom of the Chute under
the Turn Roll Assembly so the four Turn Rolls fit through the opens in the Chute.
11. Use two screws to secure the Turn Chute to the printer frame.
12. Reinstall the Main Paper Handlin g Assembly (RRP 9.36).
13. Reinstall Tray 1 into the printer.