magicolor 330 - Base Engine Service Manual 3-13
Primary FIPS: Error Messages
3.10 - Error Message: Put <Size> Paper in OPT1 BinOPT1 tray is out of paper.
Logic control on the MCU PWB detected that the No Paper Sensor in Tray 2 is actuated. The Engine Diagnostic
Menu may refer to the the OPT1 Bin no paper sensor as Tray 2 no paper sensor..
Step Actions and Questions Yes No
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially or
completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the LCIF with the MCU PWB
1LCIF TRAY INSPECTION
Slide OPT1 tray out of the LCIF.
Is the Tray out of paper?
Load paper
into the Tray.
Go to step 2
2NO PAPER SENSOR TEST
1. Enter Diagnostics and test OPT1/Tray 2 No Paper Sen-
sor.
2. Manually actuate and de actuate the No Paper Sensor.
Is "actuated" displayed when you manually actuate the sen-
sor? And, is "not actuated" displayed when you manually
deactuate the sensor?
Go to step 3 Replace OPT1/
Tray 2 No
Paper Sensor
Assembly
(LCIF RRP
6.23)
3Replace the Feeder PWB (LCIF RRP 6.10)
Does the error message still appear?
Go to step 4 Problem
Solved
4Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
Go to suspect
components
Problem
Solved