Minolta 330 6, 7, 8, 9, 10 , 11 , 12

3-24 magicolor 330 - Base Engine Service Manual
Primary FIPS: Error Messages
3.23 - Error Message: Paper Jam Fuser, continued
Step Actions and Questions Yes No
6PAPER INSP ECT ION
Inspect the jammed sheet of paper.
Is the paper damaged from or caught on the Stripper Fingers
that are located at the exit of the Fuser Rolls?
Replace the
Main Fuser
Assembly
(RRP 9.81)
Go to step 7
7PAPER INSP ECT ION
Inspect the jammed sheet of paper.
Is the paper damaged or accordion folded at the entrance to
the Fuser Rolls?
Go to step 8 Go to suspect
components
8FUSER COVER FAN INSPECTION
Inspect the Fuser Cover Fan.
Is the Fan rotating?
Go to step 9 Replace Fuser
Chute Fan
(RRP 9.131)
9FUSER DRIVE INSPECTION
1. Remove the Fuser Assembly from the printer.
2. Inspect the FT1 Input Gear (PL9.4.15) that is located
near the Heat Rod AC plug at the rear of the Assembly.
Is the gear undamaged?
Go to step 10 Replace the
Main Fuser
Assembly
(RRP 9.81)
10 FUSER DRIVE CHECK
1. Remove the Fuser Assembly from the printer.
2. Hand rotate the FT1 Input Gear (PL9.4.15) that is
located near the Heat Rod AC plug at the rear of the
Assembly (The Gear should provide a good deal of
resistance to hand rotating)
Does the gear turn, and do the Fuser Heat Roll and Pressure
Roll also rotate.?
Go to step 11 Replace the
Main Fuser
Assembly
(RRP 9.81)
11 FUSER DRIVE ASSEMBLY INSPECTION
1. Remove the Fuser Assembly from the printer.
2. Look inside the empt y Fuser cavity.
3. Inspect the drive gear at the rear of the cavity.
Is the gear undamaged?
Go to step 12 Replace the
Fuser Drive
Assembly
(RRP 9.110)
12 PAPER HANDLING MOTOR TEST
Enter Diagnostics and test the Paper Handling Motor.
Does the Paper Handling Motor rotate when you run the Paper
Handling Motor Test?
Go to suspect
components
Replace the
Paper Han-
dling Motor
Assembly
(RRP 9.111)