magicolor 330 - Base Engine Service Manual 3-5
Primary FIPS: Error Messages

3.2 - Error Message: Waste Toner Box Full

The Waste Toner Box is full.
Logic control on the MCU PWB detected that the Waste Toner Sensor was on for 1250 print cycles.
Step Actions and Questions Yes No
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially or
completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the components
• Waste Toner Box auger drive train
1Replace the Waste Toner Box with a new one (RRP 9.49)
Does the error message still appear?
Go to step 2 Problem
Solved
2WASTE TONER SENSOR TEST
1. Remove the OPC Drum (RRP 9.48).
2. Enter Diagnostics and test t he Waste Toner Sensor.
3. Manually block the Waste Toner Sensor.
In the diagnostics, is "actuated" displayed when you manually
block the sensor? And, is "not actuated" displayed when you
do not block the sensor?
Go to step 3 Replace the
Waste Toner
Sensor (RRP
9.53)
3Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
Go to suspect
components
Problem
Solved