magicolor 330 - Base Engine Service Manual 9-189
Removal and Replacement Procedures
RRP 9.92 Exchange Solenoid (PL9.3.16)
Removal
1. Remove the Oil Cam Solenoid (RRP 9.93).
2. Remove the Exchange Chute (RRP 9.91).
3. Remove the screw secu ring the Exchange Bracket to the Fuser Tray and slide the Exchange Brac ket
out of the Tray (Figure 1).
4. Remove the two screws securing the Exchange Solenoid to the Exchange Bracket and remove the
Solenoid (Figure 2).
Replacement
1. Reinstall the Exchange So lenoid onto the Exchange Bracket.
2. Line up the two screw hol es in the Solenoid with the two screw holes in the Bracket.
3. Use two screws to secure the Solen oid to the Bracket.
4. Line up the positioning tab on the Fuser Tray with the posi tioning hole in the Exchange Bracket and
reinstall the Bracket the Tray.
5. Reposition the Bracke t as necessary to make sure the Oil Cam Assembly shaft fits through the hole i n
the Bracket and the Idler Gear shaft fits into the hole in the Fuser Tray.
6. Use two screws to secure the Exchange Bracket to the Fuser Tray.
7. Reinstall the Exchange Chute ( RRP 9.91).
8. Reinstall the Oil Cam Solenoi d (RRP 9.93).