magicolor 330 - Base Engine Service Manual 9-101
Removal and Replacement Procedures
RRP 9.48 Xerographic Cartridge (PL6.1.11)Removal
1. Open the Front Cover.
2. Lower the IBT Tension Lever.
3. Move the Xerographic Cartr idge locking lever to the right.
4. Pull the Xerographic Car tridge approximately eight inches out of the print engine.
5. Use one hand to hold onto the Cartridge strap and use th e other hand to pull the Cartridge free of the
print engine.
6. Place the Xerographic Cartridge in a light-tight bag to protect the Xerog raphic Drum from light dam-
age.
The Xerographic Drum, the large blue cylinder, is easily damaged. Use extreme care
when removing or storing the Cartridge so it does not get scratched or nick ed.
Replacement
1. Open the Front Cover.
2. Lower the IBT Tension Lever.
3. Move the Xerographic Cartr idge locking lever to the right.
4. Use one hand to hold onto the Cartridge strap and use the other hand to push the Cartridg e into the
print engine cavity.
5. Line up the rail at the top le ft of the Cartridge with the rail in the print engine cavity.
6. Keep the Cartridge leve l as you carefully push the Cartridge into the cavity.
7. When the Cartridge is completely inside the cavity, move the locking lever to the left to lock the Car-
tridge in place.
8. Pull out on the Cartridg e to make sure it is secured in place.
9. Raise the IBT Tension Lever.
10. Close the Front Cover.
11. If your printer configuration does not support the CRUM automatic life counter reset, then refer to Sec-
tion 9 of this manual and reset the Xerographic Cartridge Life Counter to zer o.