iv magicolor 330 - Base Engine Service Manual
FEDERAL COMMUNICATIONS COMMISSION NOTICE
This equipment has been tested and found to comply with the limits set for a Class B digital device, as
stated in Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a commercial installation. This equipment generates, uses, and can radiate radio
frequency energy. If not installed and used in accordance with the instructions provided, this equipment
may cause disruptive interference to nearby radio and television communications. Even if the equipment
is installed according to the instructions, there is no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause disruptive interference to nearby radio and television
reception, switch the equipment off to determine if it is the true cause of the interference. If the equip-
ment is the cause of the interference, the user should try to minimize the interference by using one or
more of the following actions:
• Either re–orient or relocate the radio/television receiving antenna.
• Increase the separation between the equipment and the radio/television receiver.
• Connect the equipment to an AC outlet that is not on the same circuit as the radio/television
receiver.
• If the previous solutions fail to bring results, you should consult either your equipment dealer or an
experienced radio/television technician.
For more information on interference, refer to the Federal Communications Commission’s booklet “How
to Identify and Resolve Radio-TV Interference Problems”. This booklet is available from the U.S. Gov-
ernment Printing Office, Washington D.C. 20402, Stock No. 004-000-00345-4.
CLASS 1 LASER PRODUCT
This Laser Printer is certified to comply with the Class 1 laser product performance standards as set by
the U.S. Department of Health and Human Services. This class of laser product has an enclosed laser
system that keeps all laser energy safely inside the fully assembled and closed printer.
The laser and output of the laser scanning unit produce a beam that, if viewed, could cause serious eye
damage. Service procedures must be followed exactly as written. Use of controls, adjustments, or proce-
dures other than those specified in this manual may result in exposure to hazardous laser radiation.