magicolor 330 - Base Engine Service Manual 9-157
Removal and Replacement Procedures
RRP 9.76 Belt Cleaner Assembly (PL8.1.30)
Removal
1. Remove the Fuser Assembly (RRP 9.80).
2. Open the Front Cover.
3. Reach in through the empty Fus er Assembly cavity and hold the bottom of the Belt Cleaner Assembly.
4. Loosen the two screws securing the Cleaner Support to the pr inter frame and remove the Cleaner
Support (Figure 1).
5. Slide the Belt Clea ner Assembly to the front of the printer and remove the Assembly through the Fus er
cavity (Figure 2).
Replacement
1. Reinstall the Belt Cleaner Assembly through the empty Fuser cavity.
2. Line up the mark on positioni ng pin at the rear of the Assembly with the mark on the positioning hole at
the rear of the printer and slide the pin into the hole.
3. Line up the two screws attac hed to the Cleaner Support with the screw holes in the printer frame.
4. Line up the front of the Belt Cleaner Assembly with the spring and support bar sticking out fr om the
Cleaner Support.
5. Tighten the two screws attached to the Cleaner Support to secu re the Support and the Belt Cleaner
Assembly to the printer frame.
6. Reach in through the Fuser cavi ty and raise and release the Belt Cleaner Assembly to make sure the
Assembly moves freely.
7. Reinstall the Fuser Assembl y (RRP 9.80).
8. Refer to Section 9 of this manual and reset the Belt Cleaner Assembly Life Counter to zero.