magicolor 330 - Base Engine Service Manual 9-143
Removal and Replacement Procedures
RRP 9.69 Cartridge Sensor (PL7.2.26)
Removal
1. Remove the Fuser Assembly (RRP 9.80).
2. Reach inside the empty Fuser cavity and slide the Cartridge Sensor Holder forward to unlatch the
Holder from the printer frame (Figure 1).
3. Move the Holder around until the s ide latches on the Holder line up with the cutouts in the frame and
the Holder is free of the frame.
4. Disconnect P/J 87 from the Cartridge Sensor.
5. Remove the screw securing the Cartrid ge Sensor to the Cartridge Sensor Holder and remove the Sen-
sor (Figure 2).
Replacement
1. Position the Cartridge Se nsor onto the Sensor Holder so the LEDs face out.
2. Line up the position tab an d screw hole on the Sensor with the two holes in the Holder.
3. Use one screw to secure the C artridge Sensor to the Sensor Holder.
4. Reconnect P/J 87 to the Car tridge Sensor.
5. Position the Holder aga inst the Holder cutout in the printer frame.
6. Move the Sensor wire har ness so it exit through the cutout at the rear of the Holder.
7. Move the Holder around unti l the side latches on the Holder line up with the cutouts in the frame.
8. Push the Holder forwar d until the front latch secures the Holder to the frame.
9. Reinstall the Fuser Assembl y (RRP 9.80).