3-10 magicolor 330 - Base Engine Service Manual
Primary FIPS: Error Messages
3.7 - Error Message: Put <Size> Paper in OPT3 BinOPT3 bin tray is out of paper.
Logic control on the MCU PWB detected that the No Paper Sensor in OPT3 Bin is actuated. The Engine Diagnostic
Menu may refer to the the OPT3 Bin no paper sensor as Tray 4 no paper sensor.
Step Actions and Questions Yes No
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially
or completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the LCIF with the MCU PWB
1LCIF TRAY INSPECTION
Slide OPT3 tray out of the LCIF.
Is the tray out of paper?
Load paper
into the tray.
Go to step 2
2NO PAPER SENSOR TEST
1. Enter Diagnostics and test OPT3 Bin/Tray 4 No Paper
Sensor.
2. Manually actuate an d deactuate the No Paper Sensor.
Is "actuated" displayed when you manually actuate the sen-
sor? And, is "not actuated" displayed when you manually
deactuate the sensor?
Go to step 3 Replace OPT3
Bin/Tray 4 No
Paper Sensor
Assembly
(LCIF RRP
6.23)
3Replace the Feeder PWB (LCIF RRP 6.10)
Does the error message still appear?
Go to step 4 Problem
Solved
4Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
Go to suspect
components
Problem
Solved