magicolor 330 - Base Engine Service Manual 9-177
Removal and Replacement Procedures
RRP 9.86 Heat Roll Heat Rod (PL9.2.20)
Removal
1. Remove the Upper Fuser Assembly (RRP 9.87).
2. Remove the shrink tubing that is covering the connec tors linking the Pressure Roll Heat Rod and the
Heat Roll Heat Rod.
3. Push out on the connector latch and disconnect the two Rods from each other.
4. Remove the screw securing t he front of the Heat Roll Heat Rod to the front of the Main Fuser Assem-
bly.
5. Free the rear of Heat Roll Heat Rod from the Fuser Rear Cover.
6. Slide the Heat Roll Heat Rod out of the Heat Roll.
Replacement
Handle the Heat Rod by the ceramic end tips. If you accidently touch the glass tube, wip e
the it clean with a soft, dry cloth.
1. Carefully insert the flat end of the Heat Rod into the rear of the Heat Roll and push the Rod unt il the flat
end exits the front of the Heat Roll
2. Use one screw to connect the fr ont of the Heat Roll Heat Rod to the front of the Main Fuser Assembly.
3. Insert the rear of the Heat Roll Heat Rod and the rear of the Pressur e Roll Heat Rod through the cut-
outs in the Rear Fuser Cover.
4. Reconnect the Heat Roll Heat Rod to the Pressure Roll Heat Rod.
5. Reinstall a new piece of shr ink tubing over the connection.
6. Reinstall the Upper Fuser Assem bly (RRP 9.87).